Our customer's have requested a Rocker Panel protector that would still allow the use of Jacking Pads. The solution, our Rocker-Panel Guards. Hard, virtually indestructible plastic, designed to protect your Rocker Panels from scraping or unsightly scratches!
Steep driveways and speed bumps can be hazardous, not to mention costly to the rocker panels on your Corvette.
At about 1 pound for the set; our new Hard Machinable Plastic "Rocker-Panel Guards" are the answer.
Now a full 3/4" thick!
- Slipery surface allows for a very low coefficient of Friction
- Extremely resistant to abrasion
- Resently redesinged to be a full 3/4" thick for more protection
- Black coloring throughout the material, never needs touch-up
- Countersunk on the backside to allow clearance from factory rivets and bolt heads
- Impact / Vibration / UV / and corrosion resistant
CNC Milled units are easy to install in approximately 1 hour. Includes all stainless steel hardware & step by step installation instructions. Best of all you can still use your jacking pucks. These "GUARDS' give you a 3/4" buffer zone between them and your expensive Rockers Panels.
Sold in pairs, these are a must have, especially if your Corvette has been lowered.
Posted by Unknown on 19th Aug 2019
Both my corvettes have these..Easy to install...just drill holes first...perfect fit...good price..
Posted by Howard on 14th Jun 2019
Product is good attention to detail is poor. Two sided tape on wrong side of rails, no extra screw in case one brakes and no instructions with package. Your quality control has gone down over the past few years.
Posted by Terry Truett on 21st Aug 2014
At first Im thinking plastic? (more on that later) Well, we will give it a try. Installation had no instructions, but, if your planning to do this you should have enough brain power to need no instructions. Nice stainless self tapping screws with big head, worked fine. I did have one that stripped out in the car metal. I was provided one additional screw so as I drilled a new hole in the plastic, I realized just how hard this material really is. It is light weight but betting it will hold up for a long time. I have one bad spot leaving parking deck where I work, chewing away on my left side every day. These things will certainly save my bottom side. I need a piece of this stuff for my front spoiler too! A must for lowered Corvettes
Posted by Steven on 17th Jan 2014
Quality machined part, have not installed yet but I imagine it will fit as designed.